Shop
Elk Wireless Recessed Door Sensor
$60.00
The Elk Wireless Recessed Door Sensor is a Supervised, Wireless Door Sensor uniquely designed for recess mounting on the inside edge of a door and its frame. The sensor is virtually invisible when the door is closed. As the door is opened or closed, the sensor transmits an open (trip) or close (restore) signal to the panel. Additionally transmitted signals include: tamper, hourly supervisory, and low battery (as needed). This sensor is compatible with Elk’s 319MHz Receivers/Panels as well as many other panels that operate on the 319.5MHz Frequency and adhere to the ITI/Interlogix protocol.
Description
Elk Wireless Recessed Door Sensor Description:
The Elk Wireless Recessed Door Sensor is a Supervised, Wireless Door Sensor uniquely designed for recess mounting on the inside edge of a door and its frame. The sensor is virtually invisible when the door is closed. As the door is opened or closed, the sensor transmits an open (trip) or close (restore) signal to the panel. Additionally transmitted signals include: tamper, hourly supervisory, and low battery (as needed). This sensor is compatible with Elk’s 319MHz Receivers/Panels as well as many other panels that operate on the 319.5MHz Frequency and adhere to the ITI/Interlogix protocol.
Features:
- Our most discrete door sensor!
- Long range and battery life
- Transmits open/close, tamper, low battery, and supervisory signals
- Uses single easy to find CR2 battery
Specifications:
- RF frequency: 319.5 MHz
- Compatibility: ELK Receivers/Panels & other panels that operate on the 319.5MHz Freq. and adhere to the ITI/Interlogix protocol
- Battery type: 3VDC “CR2” lithium
- Operating Temp Range: -40 to 140°F (-40 to 60°C)
- Dimensions 2.25” L x .75” D
Programming (Enrollment)
The following is a general guideline for programming (enrolling) a sensor into the receiver or panel. For more extensive instructions please refer to the receiver or panel instructions.
- 1. Place the panel into the Program mode.
- Proceed to the WIRELESS SETUP menu.
- Select the appropriate zone/sensor location number.
- When prompted by panel to trip the sensor for learning: First Remove cap from sensor using a coin or screwdriver
• If present pull the battery pull tab out to power the sensor
• The panel should acknowledge learning the sensor in by keypad display and/or audio alert (depending on the panel). If enrollment fails to occur repeat the process but remove and reinstall the battery OR try pressing and releasing the tamper plunger. - Repeat the above process for any additional wireless
sensors. Proceed to the zone programming to assign each
sensor’s zone definition. - Lastly, Exit programming mode when finished
Please check out our YouTube Channel for more information.
Cristen Cordova –
Doors are safe from intruders! I am happy I have installed this at our home. Now, I can say we are definitely safe.