Elk 4 Button Keyfob Description:

The Elk 4 Button Keyfob is a Wireless 4 Button Handheld device which can be used to arm or disarm the alarm system. It also features two additional buttons that can be utilized to execute other functions, depending on the functionality provided by the control. Examples: Panic, Aux trigger, Lighting, etc. The device also sends low battery (as needed) and is powered by a single (1) replaceable 3VDC lithium coin-cell battery. In addition, this sensor is compatible with Elk’s 319MHz Receivers/Panels as well as many other panels that operate on the 319.5MHz Frequency and adhere to the ITI/Interlogix protocol.

Programming (Enrollment)

The following is a general guideline for programming (enrolling) a sensor into the receiver or panel. For more extensive instructions please refer to the receiver or panel instructions.

1. Place the panel into the Program mode.
2. Proceed to the WIRELESS SETUP menu.
3. Select the appropriate zone/sensor location number.
4. Start the panel sensor Enroll process. When the panel prompts to trip the sensor for learning do the following: – Press the ARM and DISARM buttons at the same time. The panel should acknowledge learning the sensor in by keypad display and/or audio alert (depending on the panel). Furthermore, If enrollment fails to occur try repeating the process.
5. Repeat the above process for any additional wireless sensors. Proceed to the zone programming to assign each sensor’s zone definition.
6. Lastly, exit programming mode when your finished

1. Place the panel into the Walk Test mode.
2. Monitor the keypad display while pressing the button. Refer to the receiver or panel for complete instructions. While In some cases the panel may provide a signal strength indication.
3. Walk away from the panel or receiver and test at various locations making sure the panel acknowledges.
4. Exit Walk Test mode when finished.

Please check out our YouTube Channel for more information.