The Honeywell Compatible Recessed Door Window Sensor is a great discrete sensor that’s also 100% compatible with DSC wireless receivers as well as Honeywell devices.

Keep in mind that every door and window in a home or office should have alarm contacts installed on it. You should always remember to include openings in the overall count. Depending on a home’s or business size, this may end up being a lot of contacts, but it’s important to avoid skipping a single door or window since each serves as a potential entry point for a burglar.

Honeywell Compatible Recessed Door Window Sensor Features:

• 100% compatible with DSC wireless receivers
• Proven reliable wireless technology
• Only choice for discrete protection
• 2.5″ x 3/4″ diameter
• Replaceable lithium battery
• 5 year battery life
• 1 inch magnet gap
• FCC and IC approved
• Industry leading 5 year warranty

Specifications:

• Frequency: 345MHz
• Operating Temperature: 32°-120°F (0°-49°C)
• Battery: One 3Vdc
• Operating Humidity: 5-95% RH non condensing
• Battery life: 5 years
• Compatible with Honeywell receivers
• Magnet gap: 1 inch max
• Supervisory signal interval: 60 min(approx.)

Enrolling

To enroll the sensor, set your panel into program mode, refer to your specific alarm panel manual for details on these menus. When prompted by the panel, trigger the sensor by moving the magnet in and out of range of the sensor. The panel will beep when you have successfully learned in a sensor.

Mounting

The recessed sensor and magnet are designed to fit snug in a ¾ inch hole and a small flange on the outer rim ensures the case cannot be pushed too far into a hole. Choose a suitable location for the sensor, drill a ¾ inch by 2.5 inch hole in the door for the sensor. Mark the location for the magnet in the frame directly in line with the sensor and drill a ¾ inch by ½ inch hole for the magnet.

Installing /Replacing the Battery

When the battery is low a signal will be sent to the control panel.

To install/replace the battery:

1. Remove the cap on the transmitter.
2. Take note of how the circuit board fits into groves on the side of the case.
3. Carefully slide out the circuit board.
4. Inspect the battery holder to determine which side the battery is inserted/removed.
5. Install /replace with a CR-2 battery ensuring the + side of the battery faces towards the circuit board.
6. Re-insert the circuit board so that the board slides within groves in the plastics.
7. Once in, replace the cap.