This is the ADT Pulse WIFI Range Extender WN2RPADT that maybe needed if your wireless ADT Pulse cameras or your WIFI ADT Pulse Keypads are too far from the iHub. Recommended when cameras are 50-75 feet from iHub.  You can only enroll one of these per ADT Pulse system. This part has been discontinued and replaced with the WN3000RPH-2ADNAS.

This is not a z-wave repeater. If you are looking for your deadbolts, thermostats, or lights to work further away than you need to install a light switch or a lamp module.

In order to add the ADT Pulse WIFI Range Extender WN2RPADT you need to click on the System Tab and then click on Manage Devices.  Then you can choose the Wi-Fi Extenders. There used to be only one to choose, but now there are two since the new one came out. Enter the MAC ID on the back of the range extender.  Then plug it in and continue. It will find the range extender very easily but may take a few minutes. Then you are done. Place the ADT Pulse WiFi Range Extender around half way in-between the camera/keypad that is not connecting well and the ADT Pulse iHub.

For more information look at the data sheet here.

This wifi extender works with all of the Wi-Fi cameras that ADT Pulse has.

These are great reasons why you should get this ADT Pulse WIFI Range Extender WN2RPADT.

It has Dynamic LEDs that clearly display the ADT Pulse connection status and signal strength between your ADT Pulse iHub Gateway and your ADT Pulse Wi-Fi Range Extender.
The wifi range extender easily enrolls to the ADT Pulse network using the ADT Pulse Portal from a computer.
Advanced security connected with Wi-Fi Protected Access (WPA2) provides improved security through advanced data encryption.
Comes with
12v power adapter
Installation guide
A stand
Weighs only .88lbs

Did you know you could add light switches, thermostats, and deadbolt locks to your ADT Pulse system? Find out more here.