Shop

Honeywell Compatible Home Disaster Sensor

(1 customer review)

$120.00

The Honeywell Compatible Home Disaster Sensor is what you need to help prevent multiple disasters in your home.  This sensor is compatible with Honeywell alarm panels equipped with wireless receivers as well as 2GIG wireless alarms. It provides water detection as well as freeze and heat detection in one device with unique wireless ID’s for each function.

This sensor comes with the Tri-Mode House Disaster Detection: Flood for broken pipes, Freeze for frozen pipes, and Heat for furnace runaway or air conditioner failure. It also has alarm differentiation for each condition, and unique wireless IDs or loops for each function.

Out of stock

SKU: 1530 Categories: , , ,
Description

The Honeywell Compatible Home Disaster Sensor is what you need to help prevent multiple disasters in your home.  This sensor is compatible with Honeywell alarm panels equipped with wireless receivers as well as 2GIG wireless alarms. It provides water detection as well as freeze and heat detection in one device with unique wireless ID’s for each function.

This sensor comes with the Tri-Mode House Disaster Detection: Flood for broken pipes, Freeze for frozen pipes, and Heat for furnace runaway or air conditioner failure. It also has alarm differentiation for each condition, and unique wireless IDs or loops for each function.

Key Instructions
  • Battery “+” faces towards spring.
  • Enrolling: To monitor multiple functions, repeat the below RF Enrollment process; each time with the SAME serial number, but with a DIFFERENT Loop number.
Honeywell Vista and Lynx Settings
  • Place Panel in Zone Programming mode (e.g. *56).
  • Zone Type = for example, 24-Hr. Aux.
  • Input Type = Supervised RF Transmitter.
  • When asked for serial number, press Tamper switch.
  • Program the desired Loop number you want that zone to monitor. Loop functions are: Loop 1: Overheat. Loop 2: Flood. Loop 3: Freeze. Loop 4: Tamper.
  • Test Temp alarm functions by putting in a freezer, or blowing a hair dryer on sensor.
  • Test Flood alarm function by putting sensor in water (distilled water will not work, but tap water should).
Specifications
  • Flood sensing: Titanium contacts 100K-Ohm nominal (DO NOT use an EOL resistor) Transmitter handles 1 or 2 flood elements, no more. 0.04 inch floor spacing to eliminate floor condensation falses. Checks for moisture every 5 seconds: needs two positive moisture checks to send Flood alarm. (test mode: every second when cover is off)
  • Freeze Alarm: 45F +/- 2F (custom temps available) Restores when temp increases 4F from alarm
  • Overheat Alarm Temp: 100F +/- 2F (custom temps available) Restores when temp decreases 4F from alarm
  • Mounting hardware: #6 or #8 screws Dual ,
  • Terminal wire capacity: 16 Gauge
  • Replacement Battery: 1550 mAH
  • Temperature Range: 0F to 120F
  • Housing dimensions: 3.3×1.4×1.1 inches

Please check out our YouTube Channel for more information.

Reviews (1)

1 review for Honeywell Compatible Home Disaster Sensor

  1. Michael Donahue

    Good thing I don’t need to Worry anymore

Add a review

Your email address will not be published. Required fields are marked *