Shop
Honeywell Compatible Door Window Sensor with External Contact Input
$65.00
The Ecolink Honeywell Compatible Door Window Sensor with External Contact Input is a wireless door/window sensor. This sensor has a sophisticated design and is compatible with Honeywell receivers. So if you’re looking for a window sensor to work with your other Honeywell devices, this is the one to get!
Description
The Ecolink Honeywell Compatible Door Window Sensor with External Contact Input is a wireless door/window sensor. This sensor has a sophisticated design and is compatible with Honeywell receivers. So if you’re looking for a window sensor to work with your other Honeywell devices, this is the one to get!
Wireless Contact with External Input (HW DWS) features:
- Built-in reed switch 5/8th in the magnet gap
- N/C external contact input
- Only 1″ x 2-5/8″ x 1/4″
- Snap-on interchangeable brown case (included)
- Replaceable lithium battery
- Case tamper
- Wall tamper
- Mounting plate
- 5-year battery life
- FCC and IC approved
Specifications:
- Frequency: 345MHz
- Operating Temperature: 32°-120°F (0°-49°C)
- Battery: 3V lithium CR2032
- Operating Humidity: 5-95% RH noncondensing
- Battery life: 5-8 years
- Compatible with Honeywell receivers
- Magnet gap: 5/8th inch max
- Supervisory signal interval: 60 min(approx.)
Enrolling
To enroll the sensor, set your panel into program mode, refer to your specific alarm panel manual for details on these menus. When prompted by the panel, trigger the sensor by moving the magnet in and out of range of the sensor. The panel will beep when you have successfully learned in a sensor.
Mounting
Included with the contact is the double-sided tape for the contact and the magnet. For reliable bonding, ensure the surface is clean and dry. Apply the tape to the sensor and then to the desired location. Apply firm pressure for several seconds.
We also recommend that you don’t mount the tape at temperatures below 50°F, although after 24 hours the bond will hold at low temperatures. The Honeywell Compatible Door Window Sensor with External Contact Input may also be mounted with screws if desired.
One side of the sensor is marked with 3 lines; this indicates the location of the reed switch. You should mount the magnet facing this side of the sensor, and it must be no further than 5/8 of an inch from the sensor. An external contact may also be connected to the WST-232 with the supplied wiring connector.
Interchangeable covers
The contract comes from the factory assembled with a white cover, but it also has optional brown covers. To change the cover, slide the front cover to disengage it from the sensor, then remove it. Replace with the brown cover ensuring the top (as marked on the inside of the cover) points away from the battery. You should hear a click when the cover engages and disengages from the sensor. You don’t need to replace the back plastic because once mounted, the back isn’t visible.
To replace the magnet cover, you will need to gently pry the white cover off with a flathead screwdriver and snap the brown cover in place
Maria Mac –
This was really a good product. Works properly and is very easy to install.