The ADT Wireless Receiver for Honeywell/Ademco Panels 40 zones  is a wireless receiver that supports as many radio frequency (RF) zones as its security system will support.

You can remotely mount the receiver away from your alarm control panel using a 4-wire connection to get a more centrally located point of wireless reception. Also keep in mind that most Honeywell security systems are only capable of using (1) wireless receiver. Therefore, consider where you will be mounting your wireless devices before you mount your wireless receiver.

Features of the ADT Wireless Receiver for Honeywell/Ademco Panels 40 zones:

This receiver’s sensitivity and noise rejection feature are both dynamically adjusted to match the ambient conditions of your property. If your security system detects unacceptably high noise levels or low RF signal levels, it will generate a trouble signal. Anytime the receiver sees an RF signal at the 345MHz frequency, the red LED on the circuit board will pulse quickly. If the wireless receiver is picking up interference, it will flash constantly or go solid.

Unfortunately, you won’t see the LED when you install this receiver remotely using the plastic cover. But the wireless receiver can generate an RF jam detection signal your security system enables that feature. Then when the wireless receiver detects a condition that could prevent proper wireless reception, it will trigger the trouble signal.

Please check out our YouTube Channel for more information.