Chat with us, powered by LiveChat
Free shipping on orders over $200
Shop  /  ADT Pulse Equipment  /  ADT Garage Door Tilt Sensor Replacement

Shop

ADT Garage Door Tilt Sensor Replacement

$55.00

The battery powered ADT Garage Door Tilt Sensor Replacement Sends door open or closed status to the ADT Garage Door Controller to reports the door’s position. It is a key attachment as without this tilt sensor, your garage door controller cannot receive accurate signals to open and close through ADT Pulse.

Description

ADT Garage Door Tilt Sensor Replacement Description:

The battery powered ADT Garage Door Tilt Sensor Replacement Sends door open or closed status to the ADT Garage Door Controller to reports the door’s position. It is a key attachment as without this tilt sensor, your garage door controller cannot receive accurate signals to open and close through ADT Pulse.

ADT Tilt Sensor

Installation:

The battery powered Tilt Sensor attaches to the top panel of the garage door.
1. Before installation, activate the Tilt Sensor by pulling and removing the battery protection strip.
2. If using screws to mount the Tilt Sensor, open the sensor case with a small screwdriver.
3. Use the double-sided tape or screws supplied to attach the Tilt Sensor to the top panel of the garage door.
NOTE: Drill two 1/16” pilot holes if using the screws to attach the mounting plate.
4. If the plate was removed for screw mounting, snap the Tilt Sensor on to the mounting plate.
NOTE: Be sure the arrow on the side of the Tilt Sensor points UP

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “ADT Garage Door Tilt Sensor Replacement”

Your email address will not be published. Required fields are marked *