The 2GIG Replacement Transformer works as a power supply for either the 2GIG Go Control or GC3 panel. Furthermore, whether you have joined the tiny home craze, live in a McMansion, or operate a commercial business that spans a tri-state area, 2GIG systems are a perfect fit for you.
is a power transformer, so the two prong input simply plugs into a standard power outlet (120 VAC @ 60 Hz). It outputs low-voltage DC current (14 VDC @ 1700 mA) on the screw terminals on the bottom of the unit. You will need to strip both ends of the cable (purchased separately) and land the raw copper on the terminals of the transformer and the panel. If you use an LT-Cable no wire-stripping is necessary. This makes the process easier for DIY installers.
Since DC power is being used, there is polarity on this power connection. Please be sure to land the red wire on the positive (+) and the black on the negative (-) on both ends. The transformer terminals are marked for polarity. Land the positive connection on terminal 1 and the negative on terminal 2 on the alarm control panel. After the connections are made, make sure to confirm there are no shorts across the terminals before powering up. To power cycle the alarm panel, we recommend that you remove the transformer from the wall outlet, instead of removing the raw leads from the panel. This avoids any possibility of shorting the live connection on the board and damaging the system.