Call: 1-800-871-2119
Shop
Door Rail 1/4″ Mount DPDT Magnet/Switch with 24″ Armored Cable
$ 80.00
Door Rail 1/4″ Mount DPDT Magnet/Switch with 24″ Armored Cable with universal magnet handles commercial and industrial overhead door applications. The Door Rail 1/4″ Mount DPDT Magnet/Switch with 24″ Armored Cable combines the installers’ choice of contact configuration with an N35 grade NdFeB magnet for maximum gap performance.
Description
Product Overview
Door Rail 1/4″ Mount DPDT Magnet/Switch with 24″ Armored Cable with universal magnet handles commercial and industrial overhead door applications.
The Door Rail 1/4″ Mount DPDT Magnet/Switch with 24″ Armored Cable combines the installers’ choice of contact configuration with an N35 grade NdFeB magnet for maximum gap performance.
FEATURES
- NO DEAD SPOT™ TECHNOLOGY
- EXTRUDED ANNODIZED (TYPE II) ALUMINUM
- QUICK SWITCH NSTALL – LESS THAN 60 SECONDS
- FLIP THE SWITCH – GAP IS NOT IMPACTED BY CABLE DIRECTION
- UNIVERSAL MOUNT
- 24″ STAINLESS STEEL ARMORED CABLE LEAD PROTECTION
- 36″ 22AWG WIRE LEADS
- LISTED TO UL634 STANDARD
Main Features
- NO DEAD SPOT technology
- Extruded anodized (Type II) aluminum
- Quick-switch install – less than 60 seconds
Technical Information
- Contact Configuration DPDT
- Contact Resistance 100000 Micro Ohm
- Contact Resistance (Ohm) 0.1
- Lead Gauge 0.87″
- Lead Gauge (mm) 22
- Lead Length 36″
- Lead Length (mm) 914.4
- Magnet Type Permanent Magnet
- Mounting Type Overhead, Track Mount
- Recommended Use Door
- Standard Gap 2.5″
- Standard Gap (mm) 63.5
- Termination Style Wire LeadsINSTALLATION INSTRUCTIONS
• Un-pack the switch and magnet assemblies and set aside the magnet bracket assembly.
• Slide the two halves of the switch bracket assembly apart so they are fully extended against the clamping screw.
• Position the switch bracket assembly on the guide roller track in the desired location. Make sure the rear half of the bracket assembly is fully extended around the track.
• Slide the bracket halves together on the track and hold the switch assembly in position. Carefully open and close the door to make sure the door will operate freely without contacting the switch or bracket assembly. ( If there is interference between the lower guide roller bracket plate and the switch bracket assembly, use the alternate mounting method below.)
• Secure the switch and bracket assembly to the track by tightening the clamping screw on the side of the bracket.
• With the door closed, align the magnet bracket assembly with the switch. Make sure there is sufficient clearance between the magnet and switch so the door can open and close freely.
• Attach the magnet to the door using #6 self-tapping screws.
• Connect an ohm meter to the switch leads and open and close the door to test the switch for correct operation.
• Connect the switch leads to the alarm system.Please check out our YouTube Channel for more information.
Maria Mac –
Great product correct order arrived! Thank you Zion Security Alarms!