The ClareOne Smoke and Heat Detector is intended to reduce false alarms from routine cooking activities while immediately identifying issues with smoke. The smoke detector sounds an alarm and then wirelessly transfers the information to the ClareOne Wireless Home and Security Panel to further signal an alert when its photoelectric (optical) sensor detects the presence of smoke. This ClareOne Smoke and Heat Detector utilizes a thermistor sensor to notify in the event of a sudden rise in temperature.

Main Features:

• Encrypted 433Mhz Technology – It features encrypted technology that prevents alarm takeovers. It can be mounted to a wall or ceiling to communicate the presence of smoke to the ClareOne Panel.
• Full Coverage for Critical Events – Features Smoke, Heat rate of rise, and heat threshold detection and conforms to UL217 8th Edition to reduce common nuisance alarms from cooking smoke.
• Audible Detection – Features a self-contained sounder when the presence of smoke is detected.
• Tamper Protected Case – Features a built-in enclosure tamper.
• Complete Supervision – Supervised transmitter and status LED.
• Simple Setup – Pairs easily and quickly with the ClareOne Panel.

Specifications:

• Frequencies: 433MHz
• Encrypted: Yes
• Transmitted indications: Tamper and low battery
• Supervisory keep-alive: 60-70 minutes
• Current drain: Typical 9μA standby
• Alarm Features Description:
  • Type: Multi-criteria
  • Test/Hush button: Checks horn circuit, silences alarm for 10 minutes
  • Audible alarm: >85 dB at 3 meters
• Temperature detection: 135º F
• Heat rate of rise detection: 15º F/Minute
• LED Indicators:
  • RED – power up, button test, in alarm, in hush, memory
  • YELLOW – power up, low battery, sensor fault, end of life
• Battery Type: (2x) CR123A
• Battery Life: Expected Life Span: 10 years
• Operating Temperature: 40° F to 100° F (4.4° C to 37.8° C)
• Operating Humidity: 15% to 95% RH non-condensing
• Dimensions (W x H x D): 4.53″ x 2.17″ (115 x 55mm)

Installation Guides:

• Select a location complying with the advice in “Location and positioning.”
• Lift off the mounting plate from the detector and discard the cardboard insert.
• Place the mounting plate on the ceiling exactly where you want to mount the alarm.
• Mark the location of the two screw holes.
• Taking care to avoid any electrical wiring in the ceiling, drill holes using a 3/16 in drill bit through the center of the marked locations.
• Push the plastic screw anchors provided into the drilled holes.
• Screw the mounting plate to the ceiling.
• If using RF Modules, then all alarms should be mounted with antennas in the same orientation. This means picking a part of the building, say the front wall of the building and then installing all mounting plates in the same orientation with respect to this.
• Power on the alarm, carefully place your thumb over the battery/batteries and remove the pull tab to activate the power.
• If there are no battery/batteries in place, only fit the designated battery type/model and ensure the orientation is correct.
• Carefully line up the alarm on to the mounting plate, gently press to the base and twist clockwise.
• Press the TEST button on each detector to ensure that the alarm works.

Please check out our YouTube Channel for more information.