The Hardwired Smoke Detector is a i3-Series conventional, two-wire, photoelectric smoke detector. You can add this detector to hardwired alarm system control panels such as ADT Premise Pro and our Safewatch pro 3000, Etc… in addition, installation is a breeze. It incorporates a plug-in design, but without the typical added costs of a plug-in detector.

Additionally, this detector has an instant inspection. Since it features both red and green LEDs, local status indication is more intuitive during power-up, standby, alarm, test, and freeze trouble conditions. And should the detector fall out of sensitivity, the red LED will blink every five seconds. There is also no need to count LEDs. With the i3 indicators, you instantly know the smoke detector’s condition.

Note that smoke detectors usually last 10 years and then need to be replaced, your smoke detectors can be replaced by just disconnecting and reconnecting the new one.

ADT Hardwired Smoke Detector Specifications:

• Alarm Current: 130mA max., limited by panel.
• Detection: Photoelectric.
• Dimensions: 2.0″ (51mm) H x 5.3″ (127mm) Dia.
• Maximum Ripple Voltage: 30% of nominal (peak to peak).
• Operating Humidity Range: 0% to 95% RH, non-condensing.
• Operating Temperature Range: 32° to 120°F (0° to 49°C)
• Voltage: 12/24 V non-polarized nominal, 8.5 min. to 35 max.
• Sensitivity: 2.5%/ft. nominal.
• Standby Current: 50 µA max. avg., 100 µA peak.
• Weight: 6.3 oz. (178 g).
• Wiring Gauge: 14-22 AWG.
• Wiring: 2-wire.
• only works if your system is hardwired

If you want some similar smoke detectors you can get our Hardwired 4-wire Smoke and Heat Detector with Siren or our Hardwired 4-wire Smoke and Heat Detector with Siren.

For more information on security or some of our products you can visit our YouTube channel here