ADT Doorbell Power Kit Description:

ADT Doorbell Power Kit comes with both the ADT Pulse and Command doorbell camera however if you need another one, this one works the same. Furthermore, it supports a doorbell with any kind of analog or digital chime usage by going between the doorbell transformers and chime wiring.

ADT stopped making these. You could try the Alarm.com Doorbell Power Module if you wanted.

Note: Before removing or attaching wires to your original bell, be sure that the power is turned off at the breaker box. Consult a licensed electrician if needed.

Installation:

1. Turn off the circuit breaker for the indoor chimer.
2. Remove the cover from the indoor chimer.
3. Loosen the “Front” and “Trans” terminal screws on the indoor chimer.
4. Connect the white wire from the Power Kit to the “front” terminal, and the black wire to the “trans” terminal. Leaving the existing doorbell wires in place. Then, re-tighten the screws.
5. Position the power kit inside your indoor chimer, away from any moving parts. Use the adhesive (foam tap) on the back of the power kit to fix it in place, if desired.
6. Attach the cover back to the indoor chimer, and turn the power on at the breaker.

Additional Info:

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this is determined by turning the equipment off and on, we encourage the user to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect The equipment to an outlet on a circuit different from that to which the receiver is connected.
• Contact Zions Security or an experienced radio/TV tech for help.

To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.