The 2GIG Compatible Micro Door Window Sensor  is an alternative wireless door and window sensor to the others that 2GIG offers. With this sensor, you won’t have to worry about any drilling or wires with installation. Its smaller size also lets it blend in with any door or window frame.

Additionally, its tamper activation means an alarm will sound when the cover is removed. So this helps prevent any vandalism and tampering with the sensor.

But if this isn’t what you’re looking for, please take a look at our other 2GIG products.

Installation:

The 3M VHB™ tape is an extremely effective adhesive. However, it also requires three things to properly bond:

1. Clean surface – any standard cleaner will work, but surface must be dry afterwards.
2. Warm temperature – if temperature is below 50F, warm the mounting surface by vigorously rubbing it with something clean.
3. Pressure – apply firm pressure for 10-15 seconds.

Here are the steps to properly install this sensor:

1. Remove 3M VHB™ tape backing
2. Place on desired location of door or window
3. External Contact: Internal magnetic switch cannot be used when external contact is installed.

Programming/Enrolling

1. Place control Panel into enrollment mode
2. Select Equipment Code (0862)
3. Remove battery tab to automatically send entire RF enrollment sequence, or activate sensor by opening the contact
4. Confirm Loop 2 is selected

2GIG Compatible Micro Door Window Sensor Specifications:

• Housing dimensions 1.8 x 0.77 x 0.39 inches
• Weight with battery 0.529 ounces
• Mounting fastener 3M VHB™ Tape
• Tamper activation Cover removal
• Operating temperature 32°F to 120°F
• Magnet trip distance 1 inch nominal
• Replacement battery Panasonic
• Battery life 6 years
• Strong, reliable RF signal Maximum FCC power