Surface Mount Terminal Extra Wide Gap Switch/Magnet Set is the installer’s choice of contact configuration where extra wide air and side-to-side gap are required to prevent false alarms caused by shifting or warping doors and windows.

FEATURES

• ENCAPSULATED HERMETICALLY SEALED CONTACTS
• ABS HOUSING
• EXTRA WIDE GAP – N35 NdFeB RARE EARTH MAGNET
• SPACER FOR STEEL DOOR INSTALLS
• SWITCH AND MAGNET BEVELED COVERS
• LISTED TO UL634 STANDARD
  
  Main Features
  • Encapsulated hermetically sealed contacts
  • ABS housing
  • Extra wide gapTechnical Information 
  • Contact Configuration N.O.
  • Contact Resistance 150000 Micro Ohm
  • Contact Resistance (Ohm) 0.15
  • Magnet Type Permanent Magnet
  • Mounting Type Steel Door, Surface Mount
  • Recommended Use Door, Window
  • Standard Gap 2″
  • Standard Gap (mm) 50.8
  • Termination Style Screw TerminalINSTALLATION INSTRUCTIONS• Remove the snap-on covers from the switch and magnet.
    • Position the switch on the door/window frame in the desired location as close to the movable part of the door /window as possible.
    • Mark the switch mounting screw locations and drill the mounting screw holes using a drill adequately sized for #6 self-tapping screws.
    • Install screws and tighten to mount the switch on the door/window frame.
    • Position the magnet on the movable part of the door/window, align the magnet with the switch as close as possible. For steel door or window applications, use the enclosed spacer under the magnet.
    • Mark the magnet mounting screw locations and drill the mounting screw holes using a drill adequately sized for #6 self-tapping screws.
    • Install screws and tighten to mount the magnet on the door/window.
    • Connect the alarm circuit leads to the terminals on the switch and test the system for correct operation.
    • Snap the covers on the switch and magnet.

  Please check out our YouTube Channel for more information.