Shop

Honeywell Compatible Wireless Motion Detector

(1 customer review)

$130.00

The Honeywell Compatible Wireless Motion Detector is what you need to monitor and keep your house safe. It’s 100% compatible with Honeywell wireless receivers. Additionally, this motion detector is pet immune, so you won’t have to worry about your furry friends accidentally setting off the alarm.

SKU: 1599 Category:
Description

The Honeywell Compatible Wireless Motion Detector is what you need to monitor and keep your house safe. It’s 100% compatible with Honeywell wireless receivers. Additionally, this motion detector is pet immune, so you won’t have to worry about your furry friends accidentally setting off the alarm.

Enrollment:

To enroll the motion sensor, set your panel into programming mode. Refer to the manual for your specific alarm control panel for details on programming mode. When prompted by the panel, enter the 7 digit serial number printed on the sensor label. Make sure the loop number is set to Loop 1.

Alternatively, the motion sensor enrolls into the system by triggering wireless transmissions. To do this, hold down the tamper button on the sensor while inserting the battery. The red LED will begin to flash. After 30 seconds, the red LED will stop flashing and the sensor then triggers by waving your hand in front of the motion sensor. The sensor will transmit every time motion is detected. Trigger the motion sensor as many times as required by your panel until the panel recognizes the sensor’s serial number.

Sensitivity Jumper Settings:

For normal sensitivity motion detection leave the jumper in the default setting (on). Remove the jumper if you desire increased sensitivity to movement.

Specifications

  • Frequency: 345 MHz
  • Operating Temperature: 32°-120°F (0°-49°C)
  • Battery: One 3Vdc Lithium (1550 mAh)
  • Operating Humidity: 5-95% RH non-condensing
  • Battery life: 5 years
  • Compatibility: Honeywell receivers
  • Pet Immunity: 50 lbs (22 kg)
  • Supervisory interval: 60 min(approx.)
  • Coverage Area: 40 x 40 feet (12m), 90-degree angle
  • Light Immunity: 2000 lux

Mounting:

Mount the motion sensor at 7.5 feet (2.3 meters) above the floor. Remove the sensor cover to expose the circuit board then remove the circuit board from the back cover by gently pressing that plastic tab as shown in the diagram. With the board removed you have access to both the flush mount and corner mount screw knockouts. Remove the appropriate knockouts and use the included screws to mount in the desired mounting location. It’s recommended to ensure there is a tight seal around the knockouts to prevent bugs from entering the sensor and causing false alarms. Replace the circuit board and snap the front cover onto the back cover.

Operation:

During normal operation, the LED will not turn on even if the sensor detects motion. This maximizes battery life. Furthermore, when the sensor detects motion and a signal transmits to the panel, the sensor will not transmit again for a period of three minutes.

Please check out our YouTube Channel for more information.
Reviews (1)

1 review for Honeywell Compatible Wireless Motion Detector

  1. Maria Mac (store manager)

    One of the best sensor!

Add a review

Your email address will not be published. Required fields are marked *